Thursday, August 30, 2018

Back to School Tips Part 3

Setting up the best classroom EVER!


Here are a few time-saving, "make my life easier" ideas that I like to do at the beginning of the year:

First, I take a photo of each child when they come in for pre-testing.  I hang up some fabric and use it as a background for the photos .  Then, when I attach their photos to the inside of their cubbies, they all coordinate with the bulletin board above it and the red checkered theme I have in my room.

Photo spot.
We will write about our favorite sandwiches on a sandwich
template and pin them on the plates.
Their photos, with the checkered background ,
will replace the old photos inside the cubbies.
I print the photos in all different sizes to use in different ways.
One way is to attach a 2" X 3" photo to card stock, laminate it, and add a sticky Velcro dot to the back.
Then, we use them to graph all kinds of things on a huge graph I made that has Velcro in each square.

Front of graphing card.
Back of graphing card.

1st Day Certificates:

Next, I printed up our 1st Day certificates:
This year, I had to change my master to "first day of TK".
Click the image to get the certificates for K.

1st Day Photo for the Memory Book:

 We took our "First Day In TK" photos!  I am hanging the frame on the bulletin board and placing the individual photos all around it for Back-To-School-Night!

That's all for now.  
Hope your new school year is awesome!

Have you signed up for your
FREE 60 day trial of ESGI yet?
Use my code, KFUN
to qualify for $40 off your 1st year.
Sign up for your FREE trial by Sept. 30
& you'll be entered to win one of 
11 Amazon Gift Cards 
valued from $50 - $500!
CLICK HERE 
to get started. 

Check out my:
FaCeBoOk:  Click Here to see my Facebook. 
(Tons of FREE ideas.)

PiNtErEsT:  Click Here to see my Pinterest Boards.  
(Oh, the ideas on these boards!)

TeAcHeRs PaY tEaChErS:  Click Here to see my TPT Store 
(Did you say, "20 freebies?!")

Find 20 FREEBIES in my
TPT STORE !

1 comment:

  1. If X150.0 was read after this move, The tool will move another 150mm in the plus course. This command is used when the tool just isn't touching the part CNC machining to speedy move, usually used when going home for a tool change and returning with a new new} tool. Some machinists prefer to speedy as close to the part as possible but I advise giving your self minimal of|no less than} 1mm clearance. Keep your hand on the feed knob and come in in} gradual for the primary time run.

    ReplyDelete